Introduction of automatic batching project of raw material system

The automatic batching project of raw material system runs stably in each transportation at the same time, and there is no blocking phenomenon. It is used in conjunction with the central dehumidification and drying system, which can clean the conveying pipeline after dehumidification and drying, so as to ensure that there is no residual granular material in the pipeline, and ensure the consistency of raw materials added to the injection molding machine while avoiding the resurgence of raw materials. Under the action of vacuum negative pressure, the original dust in raw materials will be filtered out through the dust filtering system, which is helpful to improve the quality of molded products.

The automatic batching project of raw material system has realized uninterrupted unmanned continuous molding operation. The system can regenerate and use the cold material at the nozzle in a fully automatic way, control all the feeding equipment, and prevent the blocking phenomenon in the storage bin, and realize full automation by setting up a central monitoring platform.

Automatic batching project of raw material system transports plastic raw materials from storage tanks to central dehumidification and drying system through centralized pipeline system, and then transports the dried raw materials to each injection molding machine. The central feeding system adopts the design mode of "one machine and one pipe" to ensure that the air in the whole system transports raw materials and prevent the dehumidified and dried raw materials from regaining moisture. At the same time, the operation in each transportation is stable and there is no material blockage. It is used in conjunction with the central dehumidification and drying system, which can clean the conveying pipeline after dehumidification and drying, so as to ensure that there is no residual granular material in the pipeline, and ensure the consistency of raw materials added to the injection molding machine while avoiding the resurgence of raw materials. Under the action of vacuum negative pressure, the original dust in raw materials will be filtered out through the dust filtering system, which is helpful to improve the quality of molded products.